wTargeted applications with large shafts such as wind turbine, propellor shaft, turning machines, etc.
wMagnetic belt is welded with steel locks on both ends. Tightening the locks ensures reliable mounting of the belt over the shaft surface
wBeing installed off-axis, two sensor heads detect the belt gap and automatically switch in between to ensure signal continuity
wShaft diameter >100mm
wPseudo absolute angle can be output when the sensors detect the gap end at the first turn
wHarsh environment of high moisture, condensation, oil, vibration
Specification
Supply Voltage
5-24 VDC
Current
150mA@5VDC, 100mA@24VDC
Interface
SSI, BISS C, RS485,HTL,TTL, 1Vpp
Resolution
Customizable
Speed
3,000RPM
Axial tolerance
±5 mm
Radial tolerance
±1 mm
Working temperature
-40...+85°C (customizable)
Class of protection
IP 68
The arc-shaped mounting holes are created on sensor heads, which ensure the sensors can fit different shaft diameters. The following figure illustrates how the system is installed with a shaft of 600mm diameter.